User Manual

10 . Install the round doublers to
the pre-reserved holes (2 places)
onthehorizontal fuselage.
13. Bevel the wing strengthen foam.
16.
Place the wing strengthen foam
between the two carbon fiber rods .
Note:
Please pay attention to the hollow-
carved letters
on the wing strengthen
foam.
Put the foam right side down.
19. Fix the
elevator to the fuselage with
3M magic tape.
--
11 .lnstall the rQ.und doublers to the
pre-reserved
holes
(4 places) on the
horizontal stabilizer.
14.lnstall
the round doublers to the
pre-reserved
holes
(4 places) on the
wing.
Please pay attention to the direction
of the
slot
on the round doubler, see
above picture for reference.
17 . Apply some C/A to the round doubler
joints.
20. Install other carbon fiber rods.
Finished carbon fiber rods
assembly
picture as shown.
21. Install the landing gears.
- 3-
12. Insert the wing fence into the
pre-reserved
slot of the middle wing and
apply some foam friendly C/
A.
15. Install the carbon fiber rods (4pcs) to
strengthen the wing as shown.
18. Apply some C/A
to all the joints of
carbon fiber rods and the wing strengthen
foam.