User Manual

GA-250 Micro Gyro Manual
GA-250 Micro Gyro Manual v3.2
Page 3 of 4
ASSAN Electronic Control Technology Co., Ltd http://www.assan.cn
Operation
Use the rudder stick to change the servo type
Status
Light
Type
1520
µ
S
/ 333Hz
760
µ
S
/ 560Hz
1520
µ
S
/ 250Hz
960
µ
S
/ 333Hz
Model List
(not a
complete
list)
Futaba S9253
Futaba S9254
Futaba S9257
Futaba S9650
Futaba S3153
Futaba S3154
Futaba BLS254
JR 8900G
JR 3400G
JR 3500G
Airtronics 94758
Airtronics 94761
Align DS410
Align DS420
Align DS510
Align DS520
Align DS610
Align DS620
Align DS650
HiTec 5925MG
HiTec 6965HB
HiTec HSG-5084MG
Ino-Lab HG-D261HB
Sanwa ERG-WRX
Robbe FS61BB
Futaba BLS251
Futaba S9251
Futaba S9256
MKS DS8910
MKS BLS980
JR 2700G
JR 8700G
JR 810G
Sky HDS-577
Sky HDS-877
LogicTech 6100G
LogicTech 3100G
HiTec HSG-5083MG
Note: if your digital tail servo is not listed in the above table, please ask your supplier or visit the manufacturer’s
website to get support information. Incorrect settings may damage the servo or may result in loss of tail control
during flight.
After you’ve selected the correct servo type, you can exit the Servo Type Selection mode by simply powering off the
gyro.
Configuration
Once you’ve connected your tail servo to the gyro, power on your system and wait for the gyro to calibrate. Now
follow the instructions below to adjust the gyro direction, right limit (high servo endpoint) and left limit (low servo
endpoint) parameters.
Note: The number of blue flashes indicates which configuration mode you are in and the number of red flashes
indicates the chosen parameter.
Step 1: Gyro Direction Reversing
Push your transmitter’s rudder stick to the left or right, and toggle the gain switch three times or more in quick
succession (ending in AVCS) until your gyro’s status light gives a combination of blue and red flashes, then release
your rudder stick to neutral.
You are now in the gyro direction reversing configuration mode.