User Manual

GA-250 Micro Gyro Manual
3/4
Operation ← Move the rudder stick to left Move the rudder stick to right →
Light
Status
● ●● ●●● ●●●●
Type
1520us / 333Hz
760us /
560Hz
1520us /
250Hz
960us / 333Hz
Futaba S9253 Align DS410
Futaba
BLS251
JR 2700G LogicTech 6100G
Futaba S9254 Align DS420 Futaba S9251 JR 8700G LogicTech 3100G
Futaba S9257 Align DS510 Futaba S9256 JR 810G
Hitec
HSG-5083MG
Futaba S9650 Align DS520 MKS DS8910 Sky HDS-577
Futaba S3153 Align DS610 MKS BLS980 Sky HDS-877
Futaba S3154 Align DS620
Futaba BLS254 Align DS650
JR 8900G Hitec 5925MG
JR 3400G Hitec 6965HB
JR 3500G Hitec 5083MG
Airtronics
94758
Sanwa
ERG-WRX
Model List
(not all)
Airtronics
94761
Robbe FS61BB
Note: if your digital tail servo is not listed in the above table, please ask your supplier or visit the
manufacture’s assist site to get support information. Incorrect setting may damage the servo or maybe
loss tail control during flight.
After you changed and got right servo type , you need exit Servo Type Selection by simply power off the
gyro.
Configuration
Connected your tail servo to the gyro, power on your system. After Gyro calibrated. Follow the
instruction, you can adjust the gyro direction, high servo endpoint and low servo endpoint as described
below.
Note: Blue Lighting number means in which setting mode, Red Lighting number means what’s your
choice.
Step 1: Gyro Direction Reversion
Pull your transmitter’s rudder stick to the left end or to the right end, toggling the gain switch three
or more times quickly. Your gyro’s red and blue both lighting steady, then release your stick to neutral.
Toggling the gain switch to Rate and AVCS one time, you will have in gyro direction reversion setting.