User Manual

Output mode setting(only available on FASST air
system ):
Turn off the transmitter, connect the battery to the
receiver, you will see the Red LED light flashing. The RED
LED flash high speed to indicate receiver is in special
output mode OR Low speed indicate receiver is under
(LS) low speed PPM normal output mode, press the F/S
button for 5-6 seconds while the Green LED is off (Rx in
signal searching status), then release the button. You
will see the Green LED will flash for about 4 - 5 seconds.
(Note: The Green LED will FLASH high speed under
special mode OR FLASH low speed under normal output
mode). If you press the F/S button a second time while
the Green LED is flashing, the receiver will change its
output mode status (special/normal), if you not press
the F/S button. Output mode will not be changed and
the Red LED will flash at its original speed.
Note: Output mode function is described in the form
below.