User Manual

LED is flashing, the receiver will change its RX-failsafe
status (on / off ),then the LED will return to Green solid
again. If you not press the F/S button .Nothing will be
changed and the LED will return to Green solid again. If
you want to cancel the RX-failsafe feature (not just turn
it off ), you can do it by binding the receiver again. After
binding operation the receiver will be back to factory
settings without any failsafe feature.
Note: If you do not set a failsafe setting, the receiver will
hold all controls at the position of the last command
received before signal was lost. When RX-failsafe is
turned on, the receiver will initiate the RX-failsafe
settings after loosing signal for over 1 second, the
receiver will hold the last received positions until the
failsafe takes over. When the RX-failsafe and TX-failsafe
feature are both turned on, the receiver will use the
TX-failsafe command.
We highly recommend you set failsafe feature while
flying your models. An example of a useful Failsafe
setting would be to shut down the model’s throttle, so
that it does not fly or drive away uncontrolled.