User Manual

Fail-safe setting:

There are two ways to set the Failsafe setting on the

CORONA 2.4GHz Spread Spectrum FASST Compatible

Receiver;

1. TX-failsafe feature: This method is to set failsafe on

the FASST transmitter and has priority (works on channel

3 only under FASST 7ch mode or on multiple-channels

under FASST multi-channel mode) while the receiver is

working on, just like the FUTABA receivers( only

available on FASST air system).

2. RX-failsafe feature: Turn on FASST transmitter and

turn on the CORONA 2.4GHz Spread Spectrum Receiver,

put all the sticks and switches to where give the control

inputs you want if the receiver looses signal and Press

the F/S button down for about 5 - 6 seconds while the

Green LED light solid (Rx in normal operation), then

release the button. You will see the Red LED will flash for

about 4 - 5 seconds. (Note: The Red LED will FLASH high

speed to indicate the RX-failsafe is turned on OR FLASH

low speed to indicate the RX-failsafe is turned off). If

you press the F/S button a second time while the Red

PAGE 1
Fail-safe setting: There are two ways to set the Failsafe setting on the CORONA 2.4GHz Spread Spectrum FASST Compatible Receiver; 1. TX-failsafe feature: This method is to set failsafe on the FASST transmitter and has priority (works on channel 3 only under FASST 7ch mode or on multiple-channels under FASST multi-channel mode) while the receiver is working on, just like the FUTABA receivers( only available on FASST air system). 2. RX-failsafe feature: Turn on FASST transmitter and turn on the CORONA 2.
PAGE 2
LED is flashing, the receiver will change its RX-failsafe status (on / off ),then the LED will return to Green solid again. If you not press the F/S button .Nothing will be changed and the LED will return to Green solid again. If you want to cancel the RX-failsafe feature (not just turn it off ), you can do it by binding the receiver again. After binding operation the receiver will be back to factory settings without any failsafe feature.
PAGE 3
Output mode setting(only available on FASST air system ): Turn off the transmitter, connect the battery to the receiver, you will see the Red LED light flashing. The RED LED flash high speed to indicate receiver is in special output mode OR Low speed indicate receiver is under (LS) low speed PPM normal output mode, press the F/S button for 5-6 seconds while the Green LED is off (Rx in signal searching status), then release the button. You will see the Green LED will flash for about 4 - 5 seconds.
PAGE 4