User Manual

第 - 5 - 页 共 7 页
Use programming card
Use programming card to set the ESC is the most ideal and convenient choice, only insert the signal line of ESC into
the programming card, select the item you want to change (see table above),press [OK] ,VALUE window displays "S.
(To restore the last option press the [RESET] then click [OK] ).
Setting (programming) item description and term explanation
★ 1 Operation mode
Forward with brake: can only move forward, when throttle reverse, it is brake. without reversing. this mode is
mainly used for racing.
Positive and negative rotation with brake: reverse function is available. when push the throttle from forward
direction to the reverse zone, Ship model is in the braking state, the throttle must return to the middle, And the
motor stops operating then reversing, this mode is mainly used for training..
Direct positive and negative rotation: When push the throttle from the middle point region to the reverse
zone, the motor reverses immediately..
★ 2 Designated region in the throttle
The designated region of the throttle are 6%, 9%, 12%, you can choose according to personal preference after
experiments
★ 3 Battery low voltage protection
To prevent the lithium battery from over-discharge damage, the ESC will monitor the battery voltage all the
time during operation, once the battery voltage is below the set value, the motor output will be cut off.
★ 4 Start acceleration
9 levels in total, the default is 6 levels , select the appropriate acceleration, according to the area and personal
habit, the higher level the faster start, but a high requirement for the discharge capacity of the battery,(if high
level
with insufficient battery capacity, it may cause abnormal start, then please reduce the level.) it’s difficult to
operate.
★ 5 Maximum reverse force