User Manual

Copyright © 2011 Eagle Tree Systems, LLC
http://www.eagletreesystems.com
Page
3
port of your eLogger V4 or V3, as shown in Figure 3. If you have a PowerPanel or other MicroSensors, those can “daisy chain” connect to
the pins on the side of your Altimeter, with the polarity as indicated on the Altimeter label. NOTE: The Standalone Cable must not be
used when connected to the eLogger!
Configuring the Altimeter with the Windows Software
If you have not already done so, set up the Recorder software as described in your instruction manual. Then, choose one or more of the
Altimeter options below:
Logging Altitude
To log altitude, just click “Hardware -> Choose Parameters to Log in the Recorder” and check the “Altitude” box.
Displaying Altitude in the Windows Software
To display the Altimeter Gauge and/or Numeric Altitude Display, click “Software, Choose Instruments to Display on the PC Screen” and
check the “Altimeter Gauge,” and/or “Numeric Altitude” boxes.
Graphing Altitude
To graph altitude, click “Data/2D Chart” and select “Altitude” for graphing.
Displaying Altitude on the PowerPanel LCD
Select “Hardware, Configure PowerPanel Display”, and choose “Altitude” for PowerPanel display.
Using the MicroSensor with your own Firmware/Microcontroller
Please see this document for information on using the MicroSensor with your own firmware:
http://www.eagletreesystems.com/support/manuals/microsensor-i2c.pdf
Troubleshooting
Below is a list of problems that may be encountered, and steps to remedy them. If your particular issue is not addressed by the below, see
the Support page on http://eagletreesystems.com or email [e-mail]. Include a full description of your problem, your
PC configuration, your Eagle Tree hardware and software versions, and any other relevant information.
Issue: Altitude doesn’t vary in my recordings
Solutions:
• Ensure that the Altimeter is connected correctly to the MicroPower
• Ensure that you are logging altitude, under “Hardware, Choose Parameters to Log in the Recorder”
Specifications (Approx)
• Measures altitude up to approx 20,000 Feet (6096 Meters) Above Sea Level
• Resolution: approx. +/- 1 foot (0.3 Meters)
• Power input (Standalone Mode) : 4V to 16V
• Weight: approximately 4 grams (0.15 oz)
• Dimensions: approximately 28 mm x 16 mm x 10 mm (1.1” x 0.62” x 0.4”)
• Precalibrated – no user calibration required
• Advanced Temperature Compensation
• Metric or English units
Limited Warranty
Eagle Tree Systems, LLC, warrants the Altimeter to be free from defects in materials and workmanship for a period of one (1)
year from the date of original purchase. This warranty is nontransferable. If your unit requires warranty service during this
period, we will replace or repair it at our option. Shipping cost to us is your responsibility. To obtain warranty service, email
[e-mail] for further instructions.
This limited warranty does not cover:
• The Software. See the Software license agreement for more information on Software restrictions.
• Problems that result from: