Packing list: Electronic equipment: 1. PP JET-8 Fuselage X 1 1. Motor 2208-2216 2200-2600kv X 1 2. Carbon tube X 1 2. Prop 5-6 inch X 1 3. Carbon sheet X 4 3. ESC 40AX 1 4. Poll Rod X 2 4. 9g servo X 2 5. Hinge X 2 5. Battery 1300-2200mah 38 X 1 6. Quickly Rod adjuster X 2 7. Wood motor mount X 1 8. M3 self-tapping screw X 4 9. Hook and Loop Tape 15cm 10. Spare PP sheet*1 Tools: 1. Wire cutters 2. Cross screwdriver 3. 1.5mm allen wrench 4. Kinfe 5. Foam Glue 6. Hot melt glue gun 7. No.
H·KING Applying foam glue on horizontal fuselage 1 \ I
Important : Wait 5 mins after applying foam glue. Then assemble fuselage. - \ I Put 1 *3mm carbon sheet into fuselage.
..����::::::::::i : ii ii ii ii iiii�Jl.12.'ll'JI AP.111¥.illfl No.fiDatllue in carbon sheet. Don't glue too much. Assemble Wing attach ment on. wing by foam � glue.
Press wing attachment appropriate. Notice the hole.
1 Assemble carbon tube with hot melt glue gun , the glue must be well-distributed.
�!!!!=-iiiii••---- Assemble carbon tube with hot melt glue gun , the glue must be well-distributed. Make sure it's flat. Also use No.502glue fix carbon sheet.
...._ .. - Now we start assr_mble fuselage.
22 Applying foam glue on fuselage(See picture), glue must be well-distributed.
�!!!!��=====ii ii iiiiii iiii i Jt'h&I iii 1111 Assemble fuselage on body from the back forward. A••emblewood motor mount on fu•el•ge by hot melt glue gun.
Then assemble motor with 4 pcs M3 screws.
H·KING
Assemble hinge with foam glue.
3 7. Assemble the pull rod. Adjust arm this step.
�..��::::iiiiiii. ii m . JJ�iZ2� �- Use carbon tube through the hole, then applying foam glue. Put the battery in the canopy. And adjust center of gravity base on the mark. Flying weight is 479g, use 2200mah 3s battery+ 40A ESC+ 2212/2200kv motor+ 6035 Prop. The thrust-weight ratio is 1.6.
