LY Manual

4. Insert 4 pieces AA battery into the holder and then attach next to receiver

with double sided foam tape or velcro for easier access.

5. Make certain both servo arms are set to 90 degrees at neutral.

6. Connect On/Off switch to battery pack and receiver.

7. Join the top and bottom hull sections with 5 screws. Make sure the sections

are properly aligned and that the mast step block is properly located.

8. Install front wheel, taking care not to compress the bearings. The wheel

should spin freely.

9. Connect steering rod clevis to steering arm. With servo in neutral, adjust the

clevis in or out to set the front wheel parallel to the centerline.