so manual

ManualsBrandsHobbyKing ManualsBrushless ESCSS Series 190-200A (2~6S) ESC (Opto only)

User instruction for RC aircraft ESC

Thanks for purchasing brushless electronic speed controller(ESC) which designed and manufactured by

Hobbyking.Improper operation may cause personal injury and equipment damage. High power system for RC model is

dangerous,strongly suggest users read the instruction carefully . We won’t assume any responsibility for personal

injury ,property damage or consequential damages resulting from our product or our workmanship.

【Main Features】

●High performance microprocessor brings out the best compatibility with all kinds of motors and the highest driving

efficiency.

●Maximum motor speed: 210000 RPM (2 poles), 70000 RPM (6 poles), 35000 RPM (12 poles).

●Smooth linear, quick and precise throttle response.Autocorrection of the end throttle.

●Unique circuit design,strong anti-interference.

●Startup mode can be set,throttle response fast,and it has a very smooth speed control linearity,Compatible with fixed

wing aircraft and helicopters.

●Multiple protection features: Low-voltage cut-off protection / over-heat protection / throttle signal loss protection.

●High power safety performance:wherever the throttle lever is, the motor won’t start immediately.

●Support cycle menu setting, simple operation.Support setting with program box.

●Throttle range can be configured to be compatible with all transmitters currently available on market.

【Wiring diagram】

(To avoid short circuit and leakage, please make sure good joint insulation .)

【ESC Functions】

►Restor factory defaults

ESC factory default state:

A Brake: OFF

B Battery type：Li-Po battery

C Low-voltage protection point: medium(3.0V/65%)

D Motor timing: autumatical

Summary of content (5 pages)

PAGE 1
User instruction for RC aircraft ESC Thanks for purchasing brushless electronic speed controller(ESC) which designed and manufactured by Hobbyking.Improper operation may cause personal injury and equipment damage. High power system for RC model is dangerous,strongly suggest users read the instruction carefully . We won’t assume any responsibility for personal injury ,property damage or consequential damages resulting from our product or our workmanship.
PAGE 2
E Acceleration start：soft F Helicopter mode：OFF G Working frequency: 8kHz H Low-voltage protection mode: decrease power ►Battery type (LiPo/NiMh/NiCd) setting ►Brake setting (with/without) ►Low-voltage protectionvaluesetting( low-voltage protection value:2.8V、3.0V、3.2V) 】►Acceleration start etting(specilized for RC helicopter) ►Helicopter mode(specilized for RC helicopter A .Helicopter1:After startup,from 0% throttle advance to 100% after 5 seconds B .
PAGE 3
music 10 low （7°-22°） EE-EE-EE-EE music 11 high （22°30°） AAA-AAA-AAA-AAA music 12 very soft BBB-BBB-BBB-BBB soft CCC-CCC-CCC-CCC music 14 Acceleration start DDD-DDD-DDD-DDD music 15 OFF EEE-EEE-EEE-EEE helicopter 1 （5S） AAAA-AAAA-AAAA-AAAA music 13 music 16 motor start helicopter mode helicopter 2 （10S） BBBB-BBBB-BBBB-BBBB music 17 music 18 music 19 music 20 music 21 music 22 motor rotation direction PWM motor frequency low-voltage protection mode CCCC-CCCC-CCCC-CCCC 8 kHz DDDD-DD
PAGE 4
After powering up,motor doesn’t work and emits warning tone(“BEEP-BEEP”,short stop after first “BEEP” No output throttle signal of receiver Check if right connection between signal wire and receiver throttle channel. Check transmitter and receiver,make sure signal output. After powering up,motor doesn’t work and emits continuous warning tone Throttle stick doesn’t put in the bottom. Move the throttle stick to the bottom and calibrate throttle again. After powering up,motor doesn’t work .
PAGE 5
● If not use ESC in a period, please disconnect battery pack.