Remote Setup Instructions

Procedure 1: This procedure is for setting the throttle with forward and reverse option
(reverse is 25% of full power by default, this avoid pulling your boat under water in
reverse)
Procedure 2: This procedure is for setting the throttle for forward operation (Avoid
going in reverse in this mode since it appear to confuse the ESC…)
Heli_Steph
like “§ § _ § § _ § §”. When hearing the third sound, push the trigger to the full reverse direction
until 1 sound §, then release the trigger to set the throttle to the middle. Wait for 2 sec., motor will
beep once and then twice § §. The ESC is now programmed, disconnect the battery. Reconnect
battery and the motor can now work by increasing the throttle. To set in reverse, you need to push
(fwd) the trigger twice, the second time you'll push, the motor will go in reverse and be fully
proportionnal to the input. The fwd control is always available and fully proportional, no need to pull
twice.
like “§ § _ § § _ § §”. When hearing the third sound, release the trigger to the middle. Wait for 2 sec.,
motor will beep once and then twice § §. The ESC is now programmed, disconnect the battery.
Reconnect battery and the motor can now work by increasing throttle. If you have the possibility
with your radio to go in reverse, please avoid to do so since it appear to confuse the ESC. If you want
to program the reverse function, please refer to procedure 1 above.