manual

•
3%
•
4% (Default)
•
5%
•
6%
•
10%
BEC Output
6.0V (Default) , 8.4V
Alien Power System LCD Program Card
Alien Power System LCD Program card can be used to set up all brushless ESC for RC aircraft and car produced by Alien Power System
except Turbo SS120A. Users can choose their desired parameter at any time.
LCD program Card Can be used as follows:
a) Working as an individual device to set the parameters of ESC.
b) Working as an USB adapter to link the ESC with PC, to update the firmware of ESC and set the parameters of ESC on PC.
Specification:
Dimension: 91mm*54mm*18mm (L*W*H)
Weight: 68g
Power supply: DC 5.0V~12.0V
How to connect the LCD program card:
1. Disconnect the battery from the ESC;
2.
Disconnect the signal cable of the ESC from the receiver; then plug it into the socket marked with ( )
3. Connect the battery to the ESC and turn on the ESC.
4.
SURPASS Gecko /Version/Date will be displayed on the LCD screen when ESC is connected, then press any buttons “Ready to connect
ESC” will be showed on the LCD Screen., this means that connection between LCD and ESC is established.
If the data connection between LCD and ESC is failed, the LCD Screen is always showing (Ready to connect ESC); Please check if signal
wire is connected correctly; if not repeat step1-3.
5. If the connection is established successfully, the first programmable item will be displayed on LCD screen. It’s ready to set the
parameters now.
Note1: Please strictly connect according to the above sequence. The sequence of step 2 and step 3 can not be reversed. Otherwise, the LCD
program card can not work properly.
Note2: A separate power is needed if the ESC is without BEC.
Connect an additional power (5-12V) to the socket marked with ( ) on the left of the LCD program card for power supply. Please be sure that
the polarity is connected correctly.
Plug the signal wire into the socket marked with( )first. Then connect an additional power (5-12V) to the socket marked with ( ). Then
switch on the ESC. If the sequence is wrong, LCD will not work properly.
Note3: The power supply should be lower than 12V, or the program card will be damaged.
Operation:
*Working as an individual device to program the ESC, the function of the buttons are as follows:
Finish
program
ming.
Turn off
the ESC
and then
turn it
on
again.