manual

Note: Please refere to the illustration and connect the wire accordingly, wrong connection may get your ESC fried.
Sensored Mode
When using a Sensored Brushless motor, the Blue motor wire A, Yellow motor wire B and Orange motor wire C of the ESC must be
connected with the Sensored motor wire A,B,C respectively. It is necessary to connect the Sensor wire to the “Sensor” socket on the ESC.
Don’t change the wires sequence optionally.
Sensorless Mode
When using a Sensorless Brushless motor, the Blue motor wire A , Yellow motor wire B and Orange motor wire C of the ESC can be
connected with the motor wires freely. If the motor runs in the opposite direction, please swap any two wire connections.
Connecting to the Receiver
Black wire RX-
Red wire RX+6.0V
White wire RX-Signal
LED Indication
When the Power wires on ESC are connected with the battery pack, the ESC can automatically identify the motor type
(Sensored/Sensorless) via LED lights
*If the ESC works in Sensored Mode, remove the Sensor wire and the ESC will automatically change to Sensorless Mode.
Item LED LED Status
Low voltage Red LED Blinking
Over-heat of the ESC and motor (95 )℃ Blue LED Blinking
Sensored Mode Red and Blue LED ON
Sensorless Mode Blue LED ON
Throttle Range Calibration
1. Turn on the transmitter, then connect ESC with the battery packs and set the direction of the throttle channel to REV; set the EPA/ATV
value of the throttle channel to 100%.
2. Press and hold the “Set” button and switch on the ESC, release the button when the Blue LED turn solid. Pull the throttle trigger to full
position, Red LED light will flashes and motor beeps once. when system confirms the position.
3. Push the throttle trigger to full Brake position, Blue LED light will flashes and motor beeps twice when system confirms the position.
4. Now trigger goes back to neutral position, both of the Red LED and Blue LED blink and motor beeps three times when system confirms
the position.
5. Turn off the ESC power switch to save the settings.
6. Turn the ESC back on. You are ready to use the ESC now.
Programmable Item and Default Settings
programmable
Items
Programmable Value
1 2 3 4 5 6 7 8 9
Cut-off Voltage 2.6V/cell 2.8V/cell 3.0V/cell 3.2V/cell 3.4V/cell No
cut-off
Running Mode Forward
w/o
Reverse
Forward with
pause then
Reverse
Forward/
Reverse
Motor timing Very Low Low Normal High Very High
Initial Acceleration Low Medium High Very High
Throttle Percent
Reverse
20% 30% 40% 50% 60% 70% 80% 90% 100%
Throttle Limit 0% 20% 30% 40% 50% 60% 70% 80% 90%
Percentage Braking 10% 20% 30% 40% 50% 60% 70% 80% 100%