User Manual

1) Remove covering from servo mounts, strut mounts, and servo lead exit holes.
2) Install aileron servos into each wing half. Run servo leads through the wing, and out the exit
holes. Later, the servo leads can be taped to the inside of the strut effectively hiding them.
3) Cut aileron hinge slots on each aileron. Use 3 hinges per aileron. Glue hinges with thin CA.
Flex the hinges a few times after the glue dries to free up the surfaces.
4) Drill holes in aileron with 2mm drill for control horn. Line up control horn clevis holes with the
hinge line.
5) Center aileron servo and aileron. Install pushrod, securing set screw on pushrod connector with
thread lock. Cut away excess pushrod material.
6) Glue anti-rotation pin into one wing panel, allowing half the pin to extend from the wing.
7) Slide wing panels together on the wing spar tube.
8) Cut the covering at the four wing strut locations on the fuselage. Just slice the covering, but do
not remove completely. Slice the covering in an “H” pattern as indicated in the photo above. This
hides the holes better after the wing struts are installed.
Wing Assembly
Pietenpol