User Manual

Airframe Assembly

Contents

1) Assembly starts with installing the elevator joiner wire. Lay it in place on the elevator halves,

centering it. Mark the location of the wired bends with a pen.

2) Cut a channel to allow the wire joiner to sit even with the leading edge of the elevator. Then, drill

a 2mm hole, centered on the hinge line at the location you marked with the elevator joiner bends.

3) Cut hinge slots in each elevator half, and the stabilizer. Use two hinges per half. Carfully fit the

parts together. The CA style hinges are held by applying thin CA to the hinges after you have set

them in place.

4) Insert tail parts to the fuselage, keeping the horizontal stabilizer perpendicular to the centerline.

Mark these locations with pen, then remove the covering from the area that will later be glued.

Pietenpol