User Manual

Firstly, the user must understand the performance of the remote control , the range and direction of throttle
control. what’s your purposes for the model you are handling. For different purpose it has different setting for the
model.
Set throttle with gun-type remote control
Cut off the main power supply of ESC, turn on the power
supply of transmitter and receiver. Pull the transmitter
throttle to the end(Max of the throttle),connect the
main power of ESC and wait for 2S ,the motor will make 3 sound of BEEP
like“∮∮__∮∮__∮∮”.When hearing the third sounds, please loose
the throttle to the middle (if you set full throttle, pull to the highest of
reverse direction.)When motor makes 1 sound ∮,the set of throttle trip has finished and stored in the ESC.
Wait for 2S, motor will make single sound for many times. After the single sound, It will make 2 continuous
sound∮∮ .At this time, it shows ESC has been ready. Motor can work by increasing the throttle
Set throttle with Panel-type remote control
●
Cut off the main power supply of ESC, turn on the power
supply of transmitter and receiver. Pull the transmitter
throttle to the end(Max of the throttle),connect the
main power of ESC and wait for 2S ,the motor will make 3 sound of BEEP
like“∮∮__∮∮__∮∮” (it shows the Max throttle is ensured by ESC.)When hearing the third sounds, please loose
the throttle to the middle (if you set full throttle, pull to the highest of reverse direction.)When motor makes 1 sound
∮,the set of throttle trip has finished and stored in the ESC.Wait for 2S, motor will make single sound for many times.
After the single sound, It will make 2 continuous sound∮∮ .At this time, it shows ESC has been ready. Motor can work
by increasing the throttle.
：
If losing the signal of receiver during the operation, the output of motor will be cut off in 1S and makes sound of
BEEP “
∮__”
with interval 1S.
( but PCM receiver lose the signal of transmitter , it will keep the normal control signal, ESC won ’t provide the
sound through motor at this time.)
※
For gun-type remote control and panel-type remote control , ESC support the set of half throttle trip .It can set the
Maximum –Minimum. The maximum – every position where between middle throttle and the Max position.(when
using the panel remote control without being back to the middle automatical ,the residence time of the maximum
throttle setting should wait for the end of the sound of battery test. For security, if the throttle is pushed when the
throttle is lower the middle the throttle, the present position should be as the lowest position. Please pay attention to
it.)
III. Start up
》
a Push the throttle to the lowest ( two-way throttle back to the middle)
If ESC has connected in circuit, please check if ESC connects battery pack. If connected battery pack, please
disconnect the battery pack.
》
b Connect ESC with battery pack.
》
c Wait for 2S, motor will make the N times sound of BEEP “
∮
__”(N=LiPo cells),( “__”means pause a while after
第 2 页 共 6 页