User Manual

7/08/12 11:41 PM
Page 8 of 16http://www.rchacker.com/diy/simonk-esc-firmware-flashing?tmpl=%2Fsystem%2Fapp%2Ftemplates%2Fprint%2F&showPrintDialog=1
Apologies for the dirty nails. These two are tricky because the heat shrink is much closer to the
board, lifting it with a screwdriver helps.
Once they are all in, we can solder our wires on then match them up with the right connections on
the programmer.
This diagram should help.
Part way there...