User Manual

7/08/12 11:41 PM
Page 6 of 16http://www.rchacker.com/diy/simonk-esc-firmware-flashing?tmpl=%2Fsystem%2Fapp%2Ftemplates%2Fprint%2F&showPrintDialog=1
Here I have my favorite pointy tool which is a stainless steel dental tool. Any sharp pin held with
pliers will do the same job.
Obviously we want the hole right over the pad.
Next get some solder on your screws, you do not want the screws getting too hot while they are
stuck in the heat shrink.