User Manual

7/08/12 11:41 PM
Page 5 of 16http://www.rchacker.com/diy/simonk-esc-firmware-flashing?tmpl=%2Fsystem%2Fapp%2Ftemplates%2Fprint%2F&showPrintDialog=1
Next you will need four very small and relatively long screws. Most people should have a few dead
servos lying about. These were from my Esky Belt heli.
What are looking for is a pointed and threaded end. If they are not pointed it will just make it a bit
more difficult but not impossible.