User Manual

7/08/12 11:41 PM
Page 4 of 16http://www.rchacker.com/diy/simonk-esc-firmware-flashing?tmpl=%2Fsystem%2Fapp%2Ftemplates%2Fprint%2F&showPrintDialog=1
I made it into a permanent fixture on my programmer by attaching it to the seldom used 10pin
header. The solid cores of stripped network wires are pushed in and held with hot glue.
That is the F20-A setup ready. Back to the blue series:
Prepare our leads. I used the female ends of two servo extension wires. You will have to cut off the
outer plastic.
I find it easier to slide the pins out before I solder them on.