User Manual

7/08/12 11:41 PM
Page 3 of 16http://www.rchacker.com/diy/simonk-esc-firmware-flashing?tmpl=%2Fsystem%2Fapp%2Ftemplates%2Fprint%2F&showPrintDialog=1
Just a small strip of the covering cut off at the corner of the pcb near the red motor wire.
With a sharp hobby knife make a small incision first and then lift from underneath to cut it. This way
you wont cut any tracks.
I made this for the F20-A with headers that were cut out of an old circuit board. The pins were bent
inwards to fit and then ground flat with the face of a Dremel cutter. I simply hold it in place while
programming. You could also attach a peg to this setup but I am already in too much trouble with
the missus.