User Manual

7/08/12 11:41 PM
Page 2 of 16http://www.rchacker.com/diy/simonk-esc-firmware-flashing?tmpl=%2Fsystem%2Fapp%2Ftemplates%2Fprint%2F&showPrintDialog=1
2 servo extension leads.
Step 1: Install your USBasp drivers.
No drivers are needed for Linux or OSX.
Windows get your drivers from here you have to manually install the drivers. Josh on Flite Test
shows how to install the drivers on Windows 7, and also how to use KKMultiTool on a HK controller
board. Worth a look.
Step 2: Programmer to ESC connections.
The HK USBasp programmer. has nice labels with handy points for testing with your multimeter.
Here is the business side of a blue series with the programming pads labeled. Do not cut your cover
off like I have here, as you will see there is no need.
And here is the F20-A with the pads exposed.