User Manual

Mi-LSM1300;
 If you want know mort, please sign in Http: //www.origin-kk.com.
3、Low voltage detection:
The low voltage alarm value of this series of receiver is set to 2.8 V, when the battery voltage is lower than 2.8 V, LED on the
rec ei ver wil l fl as h an d the pow er h al ved, but s e rv os ca n be co nt rol led .
4、States description for LED:
 Constant lighting: the receiver has received signal;
 Slow flash: the receiver hasn’ t received signal;
 Fast flash: Hardware malfunction or low voltage warning;
 Skip flash: the receiver has come into binding mode.
5、Programming function:
In order to let you use this series receiver more flexible and conveniently, we develop four programming functions for it.
These four ones are simple, you only need to set up the right switch on the module according to the required functions, then go
on wit h th e bin din g operati on, w hen this done, th e progr am m ing oper ation i s c om plet ed, t oo. If y ou w ant to c ha nge t he
progr ammi ng c ont ent, j us t r eset th e swi tch.
 Programming project A: choose the ESC type.
SW1  ON: Internal brush ESC;
SW1  OFF: External ESC.
 Programming project B: rudder and aileron exchange.
SW2  ON: Exchange;
SW2  OFF: No exchange.
 Programming project C: exchange servo A and servo B, this is to correct the connection error of the rudder and the elevator,
or t he ail eron a nd t he el ev at or to t he r ec eive r.
SW3  ON: Exchange;
SW3  OFF: No exchange.
 Programming project E: “Mul-CH” agreement selection, this function is for using the multi-axial digital linear servo
Mi-LSM2400 on Mi-010ARX-S, and make CON3 and CON4 output opposite-direction aileron or rudder signals.
SW5  ON: Open “Mul-CH”agreement;
SW5  OFF: Close “Mul-CH”agreement.
NOTE: * Please see the addendum for the distribution of CON1, CON2, CON3, CON4 on the receiver;
* SW1~SW5 are the switches for module.
6、Binding:
1) First power on the receiver, after about 5s, the receiver come into binding mode (LED turns from slow flash to skip flash);
2) Power on the transmitter, press the bind switch on the module(first set the program switch if needed), when the green LED
turns from dark to bright, then from bright to dark, loosen the bind switch, then module comes into binding mode, and the red
LED o n th e mod ule tu rns to fast fl as h;
3) In about 3s, the LED on the receiver turns from skip flash to slow flash, then to constant lighting;
4) If the transmitter can operate the receiver, then it succeeds.
NOTE: Must be bind in the first time.