User Manual

 If you want know mort, please sign in Http: //www.origin-kk.com.
3、Low voltage detection:
The low voltage alarm value of this series of receiver is set to 2.8V, when the battery voltage is lower than 2.8 V, LED on the
rec ei ver wil l fl as h an d the pow er h al ved, but s e rv os ca n be co nt rol led .
4、States description for LED:
 Constant lighting: the receiver has received signal;
 Slow flash: the receiver hasn’ t received signal;
 Fast flash: Hardware malfunction or low voltage warning;
 Skip flash: the receiver has come into binding mode.
5、Programming function:
In order to let you use this series receiver more flexible and convenient, we develop five programming functions for it.
These five ones are simple, you only need to set up the right switch on the module according to the required functions, then go on
with the binding operation, when this done, the programming operation is completed, too. If you want to change the programming
content, just reset the switch.
 Programming function A: choose the ESC type.
SW1  ON: Internal brush ESC;
SW1  OFF: Internal brushless ESC, or external ESC.
 Programming function B: Rudder and aileron channel exchange, this make Type H can apply to micro triangle airplane.
SW2  ON：Exchange;
SW2  OFF：No exchange.
 Programming function C: exchange servo A and servo B, this is to correct the connection error of the rudder and the
elevat or, or t he aile ron a nd the elev ator t o the r eceiv e r.
SW3  ON：Exchange;
SW3  OFF：No exchange.
 Programming function D: CON3 output channel selection.
SW4  ON: Output fifth channel;
SW4  OFF: Output fourth channel.
 Programming function E: movement direction selection on CON2 and CON3 (only for Output fourth channel of CON3), this
function is important to applying two linear servo model airplane on aileron.
SW5  ON: Reverse motion;
SW5  OFF: Coincidental motion.
NOTE: * Mx-0104ARX-LS doesn’ t support programming project D and E;
* Please see the addendum for the distribution of CON1, CON2, CON3, CON4 on the receiver;
* SW1~SW5 are the switches for module.
6、Binding:
1) First power on the receiver, after about 5s, the receiver come into binding mode (LED turns from slow flash to skip flash);
2) Power on the transmitter, press the bind switch on the module(first set the program switch if needed),when the green LED
turns from dark to bright, then from bright to dark, loosen the bind switch, then module comes into binding mode, and the red
LED o n th e mod ule tu rns to fast fl as h;
3) In about 3s,the LED on the receiver turns from skip flash to slow flash, then to constant lighting;
4) If the transmitter can operate the receiver, then it succeeds.