Operation Manual
8. Water
81
Emptying the water system
• Use the control panel to switch o the electricity for the water
pump
o
by pressing the main switch for a longer period of time
(3 - 4 seconds).
• Open all of the water taps
p
to the centre setting.
• Hang up the adjustable shower head in the shower.
• Open the outlet valves
q
on the therme (The therme is located
by the queen-sized bed/seating arrangement.).
• Unscrew the cap on the cleaning port of the fresh water tank
j
.
• Unscrew the overow pipe
l
in the fresh water tank.
• Remove the lid of the water tank. Take out the water pump and
hold it up until the water pipes have emptied completely.
• Check whether the tank, therme, faucets and pipes have emp-
tied completely. If necessary, blow out any remaining water in
the pipes using compressed air (max. 0.5 bar).
• Re-insert the overow pipe and the water pump in the fresh
water tank and close the openings.
• Leave the faucets
p
and the outlet valves
q
open.
• Clean the tanks and rinse them thoroughly.
• Allow the water system to dry for as long as possible.
• Do not forget to empty the toilet cassette.
8
Diagram of hot water supply
7
6
8
If the vehicle is not being used and there is a danger of
sub-zero temperatures be sure to drain the entire wa-
ter system. Leave taps turn on in the middle position.
Leave all drain valves open.
Only empty your waste water tank at the special-
ly designated disposal points and never in open
spaces! As a rule disposal points can be found at
motorway service stations; campsites and petrol
stations.
1
Alde outlet valve
If an Alde hot water heater has been installed, the water
runs o through an outlet value
j
on the hot water
heater instead of through the therme (see also 10.5).
Outlet valves for therme
Alde outlet valve