Operation Manual

12. Maintenance and upkeep
114
• Unscrew the light bulb
m
from the socket and exchange it for
a new one.
• Carry out this procedure in reverse to put everything back in
place, taking care to ensure that the writing on the lamp
n
is
not upside down.
4
5
If several light bulbs have to be replaced, take care to
ensure that the lamps are not accidentally switched
and that everything goes back in its original place.
Changing the licence plate illumination
• To change the licence plate illumination, rst unscrew these
screws
o
.
• Release the two cables
p
and attach them to the new light
(any connection can be chosen).
• When putting in the new light, take care to ensure that the clo-
sed side
q
of the light points towards the plastic on the ligh-
ting support
r
. Otherwise there is a danger that the plastic
on the lighting support will melt when heat is generated.
• Firmly tighten the screws
o
to fasten the illumination securely.
6
7
8
9
Changing the bulb
Writing on the lamp must not be upside
down
Registration plate light
Releasing the cable
Lamp