Operation Manual

07-9
Level of the tank
• After pressing the "right" or "left" key once, the
menu for displaying the level of the fresh water
tank appears.
• In the example, the tank is 1/4 full. The values
measured and displayed are shown as:
empty, 1/4, 1/2, 3/4 and full.
Outside temperature
• After once again pressing the "right" key, the
menu for displaying the outside temperature
appears. The sensor for the outside tempera-
ture is located below the oor of the vehicle to
the left or right of the door sill.
• The display is shown in increments of 0.5° C.
Battery voltage
• After once again pressing the "right" key, the
battery voltage of the connected battery is
displayed.
• Under normal circumstances (i.e. no battery
has been built into the camper) this will be the
voltage of the base vehicle battery.
• If the base vehicle is not coupled to the
camper, a voltage of "0.0" V will be displayed.
The sensor for the inside tempe-
rature is located on the reverse of
the circuit board of the LCD panel.
Possible heat build-up here may
cause an incorrect temperature to be
displayed.
Inside temperature
• After once again pressing the "right" key, the
menu for displaying the inside temperature
appears.
• The display is shown in increments of 0.5° C.