Operation Manual

03-4
Unhitching
5
Controlling the stabilizing device
Nach Ankuppeln und Aktivieren der
Stabilisierungseinrichtung kann der Zustand der
Reibelemente kontrolliert werden:
- After having hitched and activated the
stabilizing device, you can then control the
state of the friction pads:
- If the wear indicator
n
is in the green
(OK) zone, the friction pads are suitable for
driving.
- If the indicator is in the yellow transition
zone, the friction pads must be replaced
without delay.
- If the indicator is in the red (STOP) zone,
there is no stabilizing function. Permission to
drive at 100 km/h is immediately cancelled.
1
2
3
• Release the overrun coupling so that the
gangway bellows
o
are expanded.
• Release the contact-breaking cable and pull
out the 13-pole plug.
• Slowly pull the lever upwards into position
k
to switch off the stabilizing device.
• Pull the lever backwards and, at the same
time, further into position
j
so that the
coupling opens.
• After the front landing wheel has been rotated
out, the camper can be disconnected from the
base vehicle.
If you do not plan on using the cam-
per for a longer period of time, you
should store it with the ball coupling
closed.
6