Operation Manual

09-6
• If the ame extinguishes again, re-ignition
takes place during the closing phase of the
fusible cut-out of the ignition safety switch
(approx. 30 seconds).
• If no ame is ignited, the control light blinks.
• If the control light does not come on at all
during the ignition process, the batteries in
the automatic ignitor (2) must be replaced.
To shut off:
• turn the operation handle (1) to position "0".
The automatic ignitor is thereby shut off.
• Apply the ue cap.
• close the bottle valve and the quick-close
valve if the unit is not used for a longer period
of time.
Changing batteries on the automatic igni-
tor:
• Ensure that the heating element is shut off.
• Unlatch the battery case (2) by pressing the
rast lever (3) to the left and swing the case
out.
• Insert a new battery of the same type.
To shut off:
• Only use a temperature-resistant (up to +70°
C) and leakproof mignon battery.
• Push the battrey case to the left side of the
automatic ignitor.
• Push the rast lever (3) to the right until the
latch clicks audibly.
Insert new batteries before the begin-
ning of each heating season.
Also note the separate operating
instructions from the manufacturer.
3
2
1
4
2