Operation Manual

08-4
8.3 Heating element
Heating element S 5002 and
S 3002
- Above: S 5002 (models 540 - 750)
- Below: S 3002 (models 400 - 495)
Place of installation:
- in the closet or the corner of the ue
Before rst use:
• Before the rst ignition, ensure that the
batteries in the automatic ignitor (2) are
working properly.
Operation:
• Open the bottle valve and the quick-close
valve in the gas line.
• Turn the operation handle (1) to the thermo-
stat position 1-10.
• Press the operation handle (1) down until it
locks. The ignition is automatic from this po-
sition, until the ame burns. The ignition spark
is audible. The control light on the automatic
ignitor (2) blinks during ignition.
• Hold the operation handle in for up to 10 se-
conds, so that the ignition fuse kicks in.
• If the gas line is lled with air, it can take up to
a minute until the gas is ready to burn. Hold
the operation lever (1) in during this period,
until the ame burns.
Never re-ignite before two minutes
have passed. Otherwise, there is
a danger of deagration! This also
applies when the ame on an already
operational heating element extin-
guishes and is re-ignited.
2
1
1
2