Operation Manual

03-6
To lock
• Pull the locking brake lever upward by the
handle (1) until it locks into place. The locking
brake lever is pressed into the nal position
by the gas pressure spring.
To release
• Press the locking brake lever back into the
original position.
The brake system must be inspected after driv-
ing 1,000 km. If the tension ball coupler can be
pushed in by hand to more than a third of the
usable overrunning path (approx. 30 mm), the
brake facilities must be adjusted. These proce-
dures should be repeated every 5,000 km, but at
least once a year.
1
3.7 Overrunning brake .
facilities