User Manual

FLYING
TIP: The C-me will perform best when the winds are below 3
mph (5 km/H).
Practice indoors before  ying outside because the controls are
more sensitive when in the Outdoor Mode. To guide the C-me to a
new position, use short movements with the Directional Control in
the desired direction. Holding the control for more than a second in
one direction will usually require movement in the opposite direction
because the C-me will have  own past the desired position.
NOTE: The LED will  ash when C-me has
acquired 7 or more GPS satellite signals and
is in the Outdoor Mode”.
Full charge
Hold until the
Take Off button
is green
Tap to takeoff
Takeoff
The C-me will immediately climb to about 1 meter indoors and
up to 2 meters outdoors.
TIP: If the Take Off button is not tapped within 5 seconds, it will
lock. Hold the lock button again to unlock.
Motor Overload Protection
When the C-me has a hard landing, crashes into a solid object or
if the propellers get stuck and cannot spin, the motors will turn
off to protect the control board. The C-me will have to be turned
off and back on again any time this happens. Both calibration
procedures should be run before the C-me is  own again.
Trimming
The trim control buttons below and to the right of the Directional
Control should be used when C-me constantly drifts in the same
direction. After the C-me takes off in calm conditions, let it sit for
a moment to see of it is stable. If it drifts in one direction, use the
opposite trim button to correct it. For example, if the drone drifts
to the left, the right trim button below the Directional Control
should be tapped until the drone stops drifting in that direction.
Flight
Please keep in mind that the Directional Controls use the pilot’s
position as a reference. Even if the drone is facing to the right,
it will move closer to you when the Directional Control is pulled
down.
Indoor Mode: Tapping the Landing
Button will make the C-me slowly
descend until it reaches the
ground and turn off the motors.
The Directional Controls can be
used while landing to guide the
drone to a speci c landing point.
On level surface
with LED steady
Tap to land