Technical information

4
90°
NO NO YES
3. Still with the radio system powered up, check that the pushrod hole in the vectoring servo wheel is 90° to the servo (this may
require removing and rotating the servo wheel to fi nd another hole for the pushrod). If necessary, also adjust the V-bend in the
vectoring pushrod so the motor will be centered. Reinstall the screw for the vectoring servo wheel.
4. Also if necessary, adjust the clevises on the elevon pushrods
so the elevons will be centered.
5. Mount the vertical stabilizer to the turtledeck with two
M3 x 6 screws.
6. Guide the rudder pushrod through the slot in the turtledeck and mount the turtledeck to the fuselage with six more M3 x 6
screws. Holding the pushrod with pliers, adjust the clevis as necessary so that when connected to the rudder horn, the rudder
will be centered.