I N S T R U C T N50 MIXER I O N S N50 MIXER MODEL N50 ML-33777 701 S. RIDGE AVENUE TROY, OHIO 45374-0001 937 332-3000 www.hobartcorp.com FORM 15340 Rev. B (Feb.
Installation, Operation, and Care of N50 MIXER SAVE THESE INSTRUCTIONS GENERAL The model N50 mixer is a 5 quart, countertop mixer equipped with 1/6 H.P. motor, #10 attachment hub, and cord and plug as standard equipment. There are a variety of attachments and accessories available for the N50, and these are explained in a separate Use and Applications Handbook which is supplied with each mixer. INSTALLATION UNPACKING Immediately after unpacking the mixer, check for possible shipping damage.
OPERATION WARNING: MOVING BEATER IN BOWL. KEEP HANDS, CLOTHING, AND UTENSILS OUT WHILE IN OPERATION. CONTROLS The ON-OFF SWITCH is used to start and stop the mixer. The GEAR SHIFT LEVER (Fig. 1) is used to change speeds. Always stop the mixer before changing speeds. To change speeds, turn the switch Off, move the gear shift lever to the desired speed, and turn the switch back On.
Attachments To install an attachment, loosen the thumb screw on the attachment hub (Fig. 1) and remove the plug. Insert the attachment into the attachment hub making certain that the square shank of the attachment is in the square driver of the mixer. Secure the attachment by tightening the thumb screw. Move the gear shift lever to the desired speed and start the mixer to operate the attachment. The meat and food chopper attachment should be operated in second or third speed.
