Food Processor User Manual

– 12 –
FORM 19353 Rev. D (Oct. 2000) PRINTED IN U.S.A.
SERVICE
Contact your local Hobart Service Office for any repairs or adjustments needed on this equipment.
Long-term service contracts are available on this and other Hobart products.
SYMPTOM POSSIBLE CAUSE SUGGESTED ACTION
Low output or bad cutting
results.
A.
B.
C.
D.
E.
Wrong cutting tool used.
Wrong combination of dicing grid
and slicing tool when dicing
(space between the two cutting
tools is too large).
Problem with blade or grating
plate.
Feeding pressure too heavy.
Build-up under cutting tool,
possibly due to ejector plate not
being in place or container is full.
Refer to Cutting Tool Guide, pages 9,10.
Refer to Cutting Tool Guide, pages 9,10.
Make sure blades or grating plates are
intact and sharp.
Provided the blades and grating plates
are sharp, a light pressure is normally all
that is required to yield the best cutting
results.
Make sure the ejector plate is always
fitted when cutting.
Cutting tool locked to shaft. Build-up between cutting tool and
dicing grid or potato chip grid.
With a little force, carefully rotate cutting
tool clockwise.