Range User Manual

– 6 –

Bumper Bars (Convection Oven Ranges Only)

CAUTION: Failure to install bumper bars may cause motor damage and may void the warranty.

Remove existing #10 screws. Position bumper bars (supplied) as shown. Replace #10 screws and secure

bumper bars (Fig. 2).

Fig. 2

Backsplash

The standard deli range is equipped with a 23" high backsplash and shelf.

1. Remove the backsplash components from the crating materials.

2. Check the backsplash component parts against the list below to ensure that all the required parts for the

backsplash installation have been obtained. (See Fig's. 3 & 4.) If any parts are missing, contact your local

Hobart service office immediately.

Backsplash Component Parts

Std. 23" high Backsplash (1) #10 Sheet Metal Screws (16)

Backsplash Channel (2)

/4-20 x 2

/16" Long Machine Screws (4)

Heat Shield (1) Shelf Assembly (1)

REAR VIEW OF RANGE

NOTES:

1. Bumper bars required for all

Convection Oven Ranges.

2. Restraining device required for

all ranges with casters.

3. Restraining device not supplied by

unit manufacturer.

RESTRAINING DEVICE

#10 SHEET METAL SCREW

BUMPER BAR

PL-50109