Spec Sheet

LXeH HOT
Undercounter
As continued product improvement is a policy of Hobart, specifications are subject to change without notice.
F40902 (08/19) Page 2 of 2 HOBART • 701 S Ridge Avenue, Troy, OH 45373 • 1-888-4HOBART • www.hobartcorp.com Printed in U.S.A.
CAD and/or Revit Files Available
LEGEND
Electrical Connections
E
Electrical connection: -/" dia. hole for " trade
size conduit; -/" AFF.
Plumbing Connections
P
Single fill and rinse connection: /" female
garden hose fitting on ' long hose supplied with
machine; F water min. for LXeH.
P
Drain connection: /" barb fitting with ' long
hose supplied with machine.
SPECIFICATIONS
Capacities
Cycle Time
(seconds) .................................
Racks per Hour ......................................
Tank Capacity – Gallons ................................
Motor Horsepower
Wash ...............................................
Rinse ............................................. .
Water Consumption
U.S. Gallons per Rack
(maximum use) .................. .
U.S. Gallons per Hour
(maximum use) ....................
Peak Drain Flow – U.S. Gallons ..........................
Temperatures F
Wash ..............................................
Rinse ..............................................
Incoming Water Temperature
(minimum recommended) ....
Heating
Tank Heat, electric
(kW) ................................
Electric Booster
(kW) ...................................
Standard " x " ( x ) Rack Complement
Flat ..................................................
Peg ..................................................
Shipping Weight
(approximate) ....................... lbs.
Crated Dimensions ......................."W x "L x "H
Left Side View
Top View
Front View
Right Side View
E STANDARD ELECTRICAL OPTIONS
Tank Heat, Booster, Pump & Controls
Voltage
Rated
Amps
Minimum
Supply Circuit
Ampacity
Maximum
Protective
Device
-// .  
/-(W)/* .  
-// .  
-// .  
NOTE: For supply connections, use copper wire only rated at C minimum.
* This system requires three power wires which includes a current carrying neutral,
an additional fourth wire must be provided for machine ground.
Accessory cord kit available for all machines.
Heat Output, BTU/Hour
Latent Sensible
, ,
MODEL:
LXeH
00-947871
REV C
WALL
9"
MIN.
9 7/16"
FLOOR LINE
RECOMMENDED
17" OR LESS
13/16"
22 5/16"
CHEMICAL BOTTLES
MAY BE LOCATED ON
EITHER SIDE OF MACHINE
32 1/2"
23 15/16"
1-1/2" TRADE SIZE
PIPE MIN. REDUCED
DOWN TO 3/4" FPT
CONNECTION (BY
CUSTOMER)
RECOMMENDED WATER
SERVICE ROUGH-IN
1/2" TRADE SIZE
PIPE MIN. W/SHUTOFF
VALVE, LINE STRAINER
& 3/4" MALE GARDEN
HOSE FITTING (BY
CUSTOMER).
17"
MAX.
LOADING
HEIGHT
1 1/16"
21"
25 9/16"
10 9/16"
43 1/2"
32 15/16"
39 1/2"
SERVICE
CLEARANCE
MIN.
TRIM STRIP
(OPTIONAL)
DETERGENT
&
RINSE-AID
ADDITIONAL CLEARANCE REQUIRED TO
SLIDE UNIT FORWARD FOR SERVICE ONLY
E1
P2
P2
P1
3
E1
P2
WARNING: Plumbing and electrical connections
should be made by qualified personnel who will
observe all the applicable plumbing, sanitary, safety
codes and National Electrical Code.
Required flowing pressure to the dishmachine is
15-65 PSIG. If pressures higher than 65 PSIG are
present, a pressure regulating valve must be installed
in the water line to the dishmachine (by others).
Pressure gauge not required on pumped rinse
machines.