User Manual

– 24 –
OPERATING THE LXe DISHWASHER
DO THIS DISPLAY SHOWS REMARKS
Press ON. Model number. Dishwasher performs self-check.
This takes 5 seconds.
FILL and ll icon lit; sump tem-
perature displayed when ma-
chine is lling.
WARMING UP and warming up
icon are displayed when booster
is preheating on models LXeH
and LXeR. This preheat could
take up to 15 minutes.
Dishwasher lls with water.
When lled, pump turns on for
10 seconds.
If door is opened during ll
cycle, ll will stop. After door is
closed, the process continues
where it stopped.
During ll, sump temperature is
displayed.
When lled, machine will main-
tain an idle state. Heat is main-
tained in both sump and/or
booster.
Open door; slide rack of dishes
into dishwasher. Close door.
READY lit and sump tempera-
ture displayed.
Detergent will be added auto-
matically during wash cycle.
Rinse Aid and Sanitizer will
be added automatically during
rinse cycle. (NOTE: Sanitizer
only used on LXeC and LXePR
models.)
Press WASH. WASH and wash icon lit; sump
temperature displayed during
wash cycle.
RINSE and rinse icon lit; rinse
temperature displayed during
rinse cycle.
Machine initiates a wash and
rinse cycle.
If door is opened during wash,
rinse, or drain cycle, cycle will
continue at point where door
was opened upon closing door.
If POWER is pressed during
cycle, machine will drain and
shut down.
When cycle is complete, reload
machine for next wash/rinse
cycle; or, if not in use, machine
will maintain idle mode.
READY lit and sump tempera-
ture displayed.
Machine will drain and shut
down if the four hour idle shut-
down time is reached.
At the end of the day, press
POWER.
DRAIN and SHUTDOWN IN
PROGRESS are displayed; then
the display shuts down.
When POWER key is pressed,
machine will drain and shut
down.