Mixer User Manual

– 16 –
Entering a Special Function
Special Function Mode allows you to access three user resettable
parameters:
• Programming Recipes, (SEt . . .rECP),
• Making Recipes Active or Inactive, (Atth . . . rECP) and
• Setting the User Access Code (SEt . . . Code).
[There are also other parameters for service use viewable in
Special Functions.] Refer to the table, right.
• Begin from Standard Timer Mode . . . (If you are in Recipe Mode,
exit by pressing the lighted Recipe button to return to Standard
Timer Mode.)
• With no Recipe buttons lighted, press Enter for 5 seconds. SPFn
. . . turn displays indicating Special Functions.
• There is a one minute timeout in Special Functions Mode: After
one minute of inactivity the control will automatically return to
Standard Timer Mode.
• Turn the Timer Dial to select one of the special functions:
SEt . . .rECP, Atth . . .rECP or SEt . . .CodE, .
• Press ENTER.
Enter the Access Code
• You must enter the code to change any recipe parameters.
• CodE . . . 0000 displays.
• Turn the timer dial to the applicable access code and press
ENTER. The default access code is 0015. Refer to the next
three pages for the applicable function.
• If the incorrect code has been entered, no is displayed in the
Step Display.
FUNCTION USED BY
SEL . . . Unit Service Technician
LASt . . . Err Service Technician
Err . . . Lo
g Service Technician
totL . . . HrS Service Technician
LASt . . . HrS Service Technician
CAP . . . HrS Service Technician
RUN . . . DiA
g Service Technician
SEt . . . CodE Authorized Operator
SEt . . . rECP Authorized Operator
Atth . . . rECP Authorized Operator
OF
STEPS
_ _
SEt rECP
SPEED TIME
OF
STEPS
_ _
Atth rECP
SPEED TIME
OF
STEPS
_ _
SEt CodE
SPEED TIME
ENTER ENTER ENTER
OF
STEPS
SPEED TIME
_ _
CodE 0000
OF
STEPS
SPEED TIME
_ _
SPFn turn
OF
STEPS
SPEED TIME
_ _
CodE 0015