User Guide

– 16 –
HOLDING CYCLE (SILENCING THE 'END OF CYCLE' ALARM)
After a cook cycle has been completed, the beeper sounds and
the oven automatically executes the Hold cycle (Step 4 of the
cooking program).
The Hold cycle will not execute if it was programmed 'off', using
Hold Temp = 000.
• Press to silence the beeper.
• Program displays "H" to indicate that the oven is in a Hold
cycle.
• The oven retains heat during a Hold cycle. Avoid
overcooking by unloading when cooking is done.
STOPPING A CYCLE
During a Cook or Hold cycle,
• Press
STOP
to stop the cycle. The light, fan and heaters
turn off, and the controller returns to Idle Mode.
If
STOP
is pressed after a cook cycle has been completed,
the oven will not execute the Hold cycle.
PAUSING A CYCLE
During a Cook or Hold cycle,
• Push the Rotate Knob to pause the cycle.
The Time and Temperature displays blink. Controller
stops counting down. Heaters and Fan turn off. Interior
lamp stays on.
The controller beeps a reminder alarm if the cycle has
been paused for over 3 minutes.
• Push the Rotate Knob to restart a cycle.
TEMPERATURE
TIME

F

C
PROGRAM
 AM

PM
STEP
1  2  3  4 
325
1
0:00
TEMPERATURE
TIME

F

C
PROGRAM
 AM

PM
STEP
1  2  3  4 
200
H
11:00
TEMPERATURE
TIME

F

C
PROGRAM
 AM

PM
STEP
1  2  3  4 
200
1
11:05
TEMPERATURE
TIME

F

C
PROGRAM
 AM

PM
STEP
1  2  3  4 
425
1
1:29
• • • HOLDING • • •
PRESS SILENCE
• • • HOLDING • • •
PROGRAM 0 STEP 4