Instruction DISHWASHERSML-38898 ML-38899 ML-104047 ML-104050 C44AW ML-103946 ML-103947 ML-104082 ML-104083 C54A ML-104199 ML-104198 C64A ML-103908 ML-103909 C88A ML-110042 ML-110041 CRS66A ML-38947 ML-38948 ML-104052 ML-104055 CRS66AW ML-103958 ML-103959 ML-104086 ML-104087 CRS76A ML-104202 ML-104201 CRS86A ML-103910 ML-103911 CRS110A ML-110044 ML-110043 CCS66A ML-104321 ML-104320 CCS66AW ML-104323 ML-104322 CCS76A ML-104325 ML-104324 CCS86A ML-104327 ML-104326 CCS110A ML-110046 ML-110045 CPW80A ML-3

– 27 –
SYMPTOM POSSIBLE CAUSE
Inadequate Rinse. 1. Dirty line strainer (Fig. 5) causing reduced water flow. Turn off
water supply, remove strainer cap and withdraw and clean screen.
Reassemble.
2. Low supply line pressure.
3. Clogged rinse nozzle(s).
Continuous Rinse 1. Rinse actuator (Fig. 16) not moving freely.
Operation. DISCONNECT THE ELECTRICAL POWER TO THE MACHINE
AND FOLLOW LOCKOUT / TAGOUT PROCEDURES. Check
actuator for movement.
Fig. 16
2. Check for foreign object in mechanism, i.e., silverware.
3. Rinse valve failed or jammed open.
4. Contact your local Hobart Service office.
No Wash Tank Heat. 1. The machine is equipped with low water safety devices which shut
off heat, if water level drops. Check for proper water level.
2. Circuit breaker to heat system tripped.
3. Check heat float for debris and free movement.
4. Steam supply valve not open completely.
5. Overtemp protector tripped.
6. Contact your local Hobart Service office.
No or Slow Fill. 1. Dirty line strainer (Fig. 5) causing reduced water flow. Turn off
water supply, remove strainer cap and withdraw and clean screen.
Reassemble.
2. Make sure doors are closed.
3. Check both upper and lower fill floats for debris and freemovement.
4. Problem with solenoid valve.
5. Drain leaks.
NOTE: If symptom(s) persists after possible causes have been checked, contact your local Hobart
Service office.