612P MODEL 1612P SLICER MODEL 1612P ML-104587 EXECUTIVE OFFICES 701 RIDGE AVENUE TROY, OHIO 45374-0001 FORM 19370 (4-95)
Installation, Operation, and Care of MODEL 1612P SLICER SAVE THESE INSTRUCTIONS GENERAL The model 1612P Slicer is equipped with a Hobart-designed motor and features the exclusive Hobart Stay-Sharp cast solid stainless steel knife. The model 1612P is available for single-phase electrical service and is furnished with a cord and plug as standard equipment. The cast aluminum base on the 1612P is coated with a durable oxford gray finish.
INSTALLATION UNPACKING Immediately after unpacking the slicer, check it for possible shipping damage. If this machine is found to be damaged, save the packaging material and contact the carrier within 15 days of delivery. Prior to installing the slicer, test the electrical service to assure it agrees with the specifications on the machine data plate. ASSEMBLY The container of oil marked Lubriplate FM0-200-AW is for machine lubrication. Refer to LUBRICATION, page 8.
OPERATION SAFETY SAFETY DEVICES INCORPORATED IN THIS SLICER MUST BE IN THEIR CORRECT OPERATING POSITIONS ANYTIME THE SLICER IS IN USE. The TOP KNIFE COVER (Fig. 2) must be in position and secured with the LATCH KNOB. The RING GUARD (Fig. 3) is not removable. The DEFLECTOR accessory, if equipped, is mounted behind the blade on a spring clip (Fig. 3). The TOP KNIFE COVER and the DEFLECTOR can be removed for cleaning.
CLEANING This machine MUST be thoroughly cleaned and sanitized after each day’s operation or anytime it is not to be used for an extended period of time. WARNING: THE SLICER KNIFE IS VERY SHARP. EXERCISE EXTREME CAUTION WHEN WORKING NEAR THE KNIFE. WARNING: UNPLUG MACHINE POWER CORD AND TURN THE INDEX KNOB FULLY CLOCKWISE BEFORE CLEANING THE SLICER. Using a mild detergent and hot water solution and a clean cloth, wipe all surfaces of the machine. Rinse using another clean cloth and fresh water.
Carefully reassemble the top knife cover to the slicer by placing it on the guide pins, rotating the latch knob counterclockwise until it drops into position, and releasing the knob. If equipped, clip the deflector accessory to the knife support. The ring guard is not removable. The Model 1612P has a cleaning leg located underneath the slicer. To clean under the 1612P, raise the front of the slicer and support it with the cleaning leg (Fig. 7). DO NOT wash any slicer components in a dishwasher.
Remove the carriage tray and set the Index Knob at 50. Unscrew the thumb screw on the sharpener and assemble the sharpener in the slot at the bottom of the gauge plate. Lift the sharpener upward in the slot and tighten the thumb screw to fit (Fig. 8). Gauge Plate Sharpener Thumb Screw (Not Shown) PL-40624-1 Fig. 8 Plug in the power cord and pull the switch knob to start the slicer.
LUBRICATION WARNING: UNPLUG MACHINE POWER CORD. The carriage slide rod reservoir (Fig. 11) should be filled monthly with several drops of Lubriplate FM0-200-AW oil. A four-ounce container of this oil was supplied with the slicer. DO NOT use vegetable oil. Occasionally, the gauge plate slide rods (Fig. 12) should be lightly coated with Lubriplate FM0-200AW (4 oz. container supplied). Turn the index knob fully counterclockwise when lubricating these slide rods, and then turn it fully clockwise when finished.
