User Guide

5G Starterkit User Guide
HMS Industrial Networks AB Page 5 of 12
Connecting the Hardware
To connect the 5G Starterkit with IO-Link sensors you will need:
• A 5G Wireless Router
• Two SIMs for the Industry Connect private cellular network (not included in the kit)
- The two SIMs should belong to the same APN
- Each SIM should have a static IP address
- The SIMs should be allowed to send IP packets to each other
• A tablet which can connect to the Industry Connect private cellular network (not included in the kit)
In addition, you will need the following during configuration:
• A laptop with an Ethernet cable
• PH2 screwdriver for mounting the SIM
Inserting the SIM in the Wireless Router
The Wireless Router uses a 4FF nano SIM. Please ensure that the PIN is disabled before inserting
the SIM.
The SIM holder is located behind a metal cover. Unscrew the two screws and remove the cover.
Take out the top SIM tray (SIM 1) and insert the SIM. Insert the SIM tray into the Wireless Router
again.
Mount the cover again and insert the screws.
Inserting the SIM in the Tablet
Follow the instructions of the tablet and insert the SIM.
Mounting the Wireless Router on the Starterkit
Unpack the Starterkit from the transport case.
Mount the Wireless Router on the DIN rail of the Starterkit (on the left side of the Starterkit). Make
sure that the antenna connectors are on the top and the power connector is on the bottom.
Power Supply
A power supply is included with the Starterkit.
• Mount the appropriate mains power adaptor for your region
• Mount the M12 connector of the power cable to the X31 port of the orange IO-Link master
• Mount the orange power connector to the small gateway between the Wireless Router and
the IO-Link master
• Mount the white power connector to the Wireless Router
• Connect the power supply to a mains outlet (230 VAC or 110 VAC)