Quick Start Guide

Before the rst use

1. Remove the battery lash

To turn on the device, you need to remove the lash on the side of the

device (pict 1). Please make sure that your gateway is turned on.

Please remove the battery lash carefully. After removal the device will

turn on. The three LEDs will light up after each other several times for

5 seconds. Then the LEDs will start blinking which indicates that the

device is trying to communicate with the gateway to set the device.

2. Mounting the carrying cord

You can wear your smartLAB

move with the carrying cord included in

the set. To do so, you will have to connect the cord to the device by

doing the following steps:

pict 1