Operation Manual

ENGLISH

III. Setup & Operating procedures

Installing batteries

The meter uses two CR 2032 3V Lithium

batteries. Batteries will normally last

for aprox. 3000 tests. Other types of

CR 3V lithium batteries are also accept-

able, yet the capacity of test times may

differ. Install the batteries when you rst use the meter by remv-

ing the battery protection or replace with new batteries when the

“LP” message and the low battery symbol appear on the LCD dis-

play. Open the battery lid on the back side of the smartLAB

mini

nG meter and insert batteries with plus sign to top. First insert

the battery on the right side and then press the left side down

until it clicks. Close the battery lid. The display will light up for

one second. Afterwards the device will turn off automatically.

Note:

1. Remove the batteries when you will not be using the meter for

one month or longer.

2. Values won’t be deleted when the batteries are replaced.

Meter, batteries, lancets, test strips etc. must be disposed

of according to local regulations at the end of their usage.

Low battery symbol