Operation Manual

ENGLISH

4. Blood glucose measurement

Hold the application zone of the test strip vertically onto the blood

sample. The blood is automatically sucked in the reaction zone of

the test strip. Be sure to get enough blood on the strip’s reaction

zone, otherwise, an inaccurate reading may result. The signal tone

indicates that enough blood entered the reaction zone. The meter

will now start with the measurement which will last 5 seconds. The

LCD display shows the remaining time of measurement in seconds.

Afterwards the note „OK“ indicates a correct measurement. The

measurement is ﬁnished with another signal beep and the meas-

ured value is shown on the display.

5. Storing memories

The displayed result is automatically stored in the memory of the

meter. If more than 480 results are reached, the oldest one is de-

leted.

After every measurement the meter tries to connect to another pre-

installed ANT or BLE partner (please refer to the chapter “Wireless

data transfer” in this manual to learn how to connect your device

with a ANT or BLE partner). The Wireless-sign will start ﬂashing. If

a connection can be established, the result will be transferred auto-

matically. In case no connection was found, “ERR” and the Wireless-

sign appears on the display. Please make sure that you set up your

wireless connection correctly according to the instructions in the

manual of your partner device.