Operation Manual

32
end of measurment. Now you can leave the tread of the scale. The scale
will deactivate automatically after several seconds.
Setting up of the user data
In order to measure the adipose content and other parameter you first have to
insert your individual user data. You can store up to 8 user profiles and recall
the measured data.
The smartLAB
®
fit W Body Analyser Scale has a special function for automatic
transfer of user profiles and other functions. It is requiered that the receiving
devices supports these functions.
With the automatic setting of the scale there is no need to setup the scale
manually. When you use the scale for the first time or you change the
batteries, the scale will check for an adiquet receiving device.
If a receiving device is in reach of the scale, it will send all the setup data to
the scale. This function has the benefit of also sending the batterie status to
the receiving device.
The automatic setting can be disabled with the function setup (please refer to
the section function setup).
If you want to set up the scale manualy please press “SET” (on the side of your
scale) to create a new user profile.
Note: The weight scale can be set by the touch function, which can be found
on the right top side of the scale. The touch function represents the buttons,
which are abreast of the Set writing and the arrows at the side of the scale.
User profile:
The display now shows several illuminated preadjustments. The symbol “P1”
appears on the display (bottom, left) for user profile 1 (see picture 1). You can
confirm this choice by pressing “SET” or you can create a new user profile by
increasing the number (arrow keys on the side of the scale).
Gender:
Press „SET“ to confirm your choice and then chose your gender. The display
Pic. 1
cm
age