Operation Manual

ENGLISH

III. Setup & Operating functions

Inserting and changing the batteries

• Please open the cover of the battery case at the back of the device.

• Insert 4 AAA batteries (1,5 V). Please pay attention to the polarity.

• Close the cover of the battery case.

Important: Please make sure that your scale is close to a gateway when

inserting and changing the batteries, so the gateway can set the scale and

send important information like date and time. The „W“-Symbol on the scale

indicates when the scale is trying to communicate with the gateway.

Note: In case the scale does not operate please remove the batteries and

insert them again.

Your smartLAB

ﬁt W Body Analyser Scale has a symbol indicating

that the batteries need to be changed. In case the batteries are

almost empty, the symbol “Lo” can be seen on the display. You

should change the batteries then.

Please remove the batteries in case you are not going to use

the scale for one month or more in order to avoid an automatic

discharge of the batteries.

The Body Analyser Scale as well as the batteries must be disposed

of according to the local regulations.

In order to guarantee a correct measurement you should calibrate

the scale always after any location change. Just tip on the scale

and wait until it shows “0.0” on the scale.

Beginning of operation / „quick weighing “

• Use the smartLAB

ﬁt W Body Analyser Scale bare-footed. Do not move so

you can stand on both legs. The scale starts measuring immediately and

ﬁnally shows your body weight on the display. A long beep will signal the