Manual

COMPATIBILITY
CircuitWorks

Conductive Epoxy is
generally compatible with most materials
used in printed circuit board fabrication. As
with any adhesive/sealant, compatibility
with substrate should be determined on a
non-critical area prior to use.
USAGE INSTRUCTIONS
Read MSDS carefully prior to use.
Cleaning: For best results, clean the board
with one of Chemtronics

Electro-Wash

or
Pow-R-Wash

cleaners in order to remove
any surface contamination which may
prevent adequate material contact.
Mixing: Mix equal amounts (1:1) by
weight or volume of Part A and Part B. Mix
thoroughly for 2 minutes and apply within 8
minutes.
Thinning: Do not attempt to thin.
Curing: Curing times and electrical
conductivity depend primarily on
temperature. For fastest curing times,
maximum conductivity and adhesion, cure
the bond between 150-250F (65-121C) for
5-10 minutes. CircuitWorks

Conductive
Epoxy can be room temperature cured at or
above 75F (25C), for 4 hours. Maximum
conductivity and bond strength are achieved
in 24 hours. Curing at temperatures below
75
 F (25C) will result in a loss of
conductivity and adhesion.
Pot Life: 8-10 Minutes at 75F (25C) after
mixing.
AVAILABILITY
CW2400 7g/ 0.25 oz. Adhesive &
7g/ 0.25 oz. Hardener
CW2400J 10g/ 0.35 oz. Adhesive &
10g/ 035 oz. Hardener
TECHNICAL & APPLICATION
ASSISTANCE
Chemtronics

provides a technical hotline to
answer your technical and application related
questions. The toll free number is: 1-800-TECH-
401.
NOTE:
This information is believed to be accurate. It is
intended for professional end users having the skills
to evaluate and use the data properly.
CHEMTRONICS

does not guarantee the accuracy
of the data and assumes no liability in connection
with damages incurred while using it.
MANUFACTURED BY:
ITW CHEMTRONICS

8125 COBB CENTER DRIVE
KENNESAW, GA 30152
1-770-424-4888
REV. J (08/10)
DISTRIBUTED BY:
Documentation Provided By HMC Electronics
33 Springdale Ave. Canton, MA 02021
http://www.hmcelectronics.com
[phone]